From: Mark McSweeny (MarkM@xxxxxxxxxxxxxxxxxx)
Date: Wed Sep 29 1999 - 03:28:52 GMT-3
Chad,
http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113ed_cr/d
ial_c/dcprt8/dcsnap.htm
The %remove the dialer profile means the command you tried to enter
is for legacy DDR.
Am just working through this part in Caslow's book, will let you know if I
found any further info.
Regards
Mark
On Wednesday, September 29, 1999 5:22 PM, Chad Marsh [SMTP:chad@wa.net]
wrote:
> Can you setup snapshot routing with Dialer Profiles?
> I cannot seem to make it work, I know you need the command 'dialer map
> snapshot', and 'dialer map' is not allowed on a Dialer interface?
> Strange, I have seen someone post a config that did have 'dialer map'
> statements under a Dialer interface, they also had 'dialer in-band'. If
> I try to put 'dialer in-band' I get the error:
> %Remove the dialer profile first
> I can get snapshot working fine on the physical interface, but that
> seems like a waste of resources.
>
> Also, can anyone describe the configuration and use of dialer
> rotory-groups? How are they different than dialer pools?
>
> Thanks much,
>
> Chad Marsh
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:51 GMT-3