From: Pesnell, Darin (Darin.Pesnell@xxxxxxxxxx)
Date: Mon Sep 27 1999 - 11:21:52 GMT-3
Peter,
Do you have a valid default route on r5? If you don't, try adding one on R5
and see if R1 see's it.
Darin Pesnell
-----Original Message-----
From: Peter Van Oene [mailto:vantech@sympatico.ca]
Sent: Monday, September 27, 1999 12:49 PM
To: ccielab@groupstudy.com
Subject: OSPF NSSA Default;'s!!
Ok, 3 days before my lab and I'm going nuts:)
I have the following R6 IGRP R1 Ospf R5
R1 is area 1
R5 is ABR
Area 1 is nssa.
I wish to propogate a default route to eventually R6, but first to R1 from
5.
my R5 config looks like this
router ospf 1
network 150.100.1.6 0.0.0.0 area 1
network 150.100.10.9 0.0.0.0 area 0
network 150.100.10.19 0.0.0.0 area 0
area 0 range 150.100.10.0 255.255.255.0
area 1 nssa default-information-originate
However on my R1, I see no type 7 LSA for 0.0.0.0 and obviously
no route shows up in the routing table. I'm losing my mind!
Any thoughts?
Peter Van Oene
Senior Systems Engineer
UNIS LUMIN Inc.
www.unislumin.com
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:51 GMT-3