VLANs across ATM PVCs

From: stella (yulingna@xxxxxxxxx)
Date: Sun Sep 12 1999 - 17:58:18 GMT-3

• Next message: Jason Aarons: "Re: Loopback use on labs"
• Previous message: Peter Van Oene: "Loopback use on labs"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
I am trying to config vlans across ATM pvcs.
I am using ATM PA on 7206 over a T-3.
Here is part of the configuration:

interface FastEthernet0/0.1
 encapsulation isl 1
 no ip redirects
 no ip directed-broadcast
!
interface FastEthernet0/0.2
 encapsulation isl 2
 no ip redirects
 no ip directed-broadcast
!
interface ATM1/0
 no ip address
 no ip directed-broadcast
 atm ilmi-keepalive
 atm ilmi-pvc-discovery
 pvc 0/16 ilmi
 !
!
interface ATM1/0.1 point-to-point
 no ip directed-broadcast
 atm pvc 10 20 30 aal5snap
!
I was told that after created different PVCs on
different ATM subinterfaces, i can use this command:
'atm bind pvc vlan 10 1'
to bind different vlans to different pvcs so that i do
not need to config lane.
but when i use 'atm ?'
i found there is no 'atm bind' command?
somebody told me they used this commnd on Catalyst5509
RSM.
but is it can only be used on Catalst not 7206 PA?
Thanks

Stella

• Next message: Jason Aarons: "Re: Loopback use on labs"
• Previous message: Peter Van Oene: "Loopback use on labs"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:50 GMT-3