From: Edward Taggart (etaggart@xxxxxxxxx)
Date: Fri Sep 03 1999 - 18:58:10 GMT-3
I have 2 bgp problems that are driving me crazy.
Question 1: I have 3 routers in the same AS. They are connected as
follows:
R3 <---> R2 <---> R5
They all can reach each other fine through OSPF routes. R5 also has a
loopback that is being redistributed via OSPF. I configured 2 peer
statments on all routers providing a full mesh for the IBGP AS (all
sessions show active). The network that the loopback's address
resides in is being advertised to BGP by R5. When doing a "show ip
bgp" it shows up in all 3 routers bgp table. However, R3 does not
advertise the route to an external AS. When doing a "debug ip bgp
update" on R3 I see that it is complaining that the loopbacks network
is not synchronized. However, the loopbacks network is in the IGP
routing table..
Now, if I remove the peer statements between R3 & R5 and setup R2 with
router-reflector-client statements, R3 advertises the route to the
loopback to the external AS.
How I understood it was that routers in the same AS do not need to be
directly connected to their peers, they just need IP reachability to
them and a full mesh peer configuration (or route a reflector). What
am I missing?
Qustion 2:
If I have an OSPF route and BGP route on a router for the same
network, what would keep the BGP route from injecting itself into the
routing table given that BGP has a lower administrative distance than
OSPF?
The following is from a "show ip bgp" command
*> 192.192.2.0 132.4.7.5 0 100 0 (1034 1099)
i
The following is from a show ip route from the same router as above:
O E2 192.192.2.0/24 [110/20] via 132.4.8.2, 00:37:01, Serial1
This particular router is in it's own AS so the 192.192.2.0 route is
coming in from AS1034 then AS1099..
Any help would be greatly appreciated. I'm looking through both
Caslow's and Halabi's books and can't seem to find the answer to these
problems.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:50 GMT-3