From: Muralidhar Devarasetty (dhar_murali@xxxxxxxxxxx)
Date: Fri Aug 06 1999 - 10:59:44 GMT-3
Does this "passive interface command" makes EIGRP not to run on that I/F or
not to advertise on that I/F? I mean with this command is the I/F will be
still in EIGRP I/F list or not?
MK
----Original Message Follows----
From: "Alex Dean" <Alex.Dean@telecom.co.nz>
Reply-To: "Alex Dean" <Alex.Dean@telecom.co.nz>
To: <ccielab@groupstudy.com>, <howard.rahmlow@unisys.com>
Subject: Re: OSPF and EIGRP
Date: Fri, 06 Aug 1999 16:44:15 +1200
Under the router eigrp configuration - use the command:
passive-interface serial 1
This will make sure it does not run on serial 1.
In terms of redistribution - make sure that you have some form of metric
specified. Otherwise more information is needed to work out why it is not
working for you.
Cheers
Alex.
>>> "Rahmlow, Howard F." <howard.rahmlow@unisys.com> 06/08/99 11:46:02 >>>
In a lab setup, I have both EIGRP and OSPF running. Here is the basic setup
Int S0
ip add 192.63.65.6 255.255.255.252
Int S1
ip add 192.63.65.9 255.255.255.252
Router EIGRP 100
network 192.63.65.0
(every time I enter 192.63.65.4, it changes in the show run)
Router OSPF 100
network 192.63.65.8 0.0.0.3 area 0
When I try and redistribute the routes, the OSPF routes make it to the EIGRP
side no problem, but the EIGRP routes are not seen on the OSPF side. If I
look at the eigrp interfaces, or neighbors, they both show S1.
Any clue?
Thanks in advance, Howard
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:46 GMT-3