From: Hutchinson, Ian (Ian.Hutchinson@xxxxxxxx)
Date: Tue Jul 20 1999 - 20:57:25 GMT-3
I am having difficulty bridging Vines across a router. Firstly, I have
confiugered 3 routers to route Vines normally. This works fine as follows:
R1
conf t
vines routing 21111111:0001
int e0
vines metric 1
R2
conf t
vines routing 22222222:0001
int e0
vines metric 1
int e1
vines metric 1
R3
conf t
vines routing 23333333:0001
int e0
vines metric
Now for the bridging config that won't work:
R1 & R3 are as above.
R2 I have enabled irb as follows and tried both the DEC & IEEE protocols:
conf t
vines routing -------------- ( I have tried with and without this
command.)
bridge irb
bridge 1 protocol IEEE ---------(I have tried DEC also)
bridge 1 bridge vines -------(I have typed this but it dosen't
register the command in running-config)
no bridge 1 route vines -------(I have added this to try to turn
off vines routing but it dosen't register the command in running-config)
int e0
bridge-group 1
no vines metric 1 ---------------(I have tried with "vines metric 1
also, but I figure this enables vines routing on the interface so it is best
left off)
int e1
bridge-group 1
I have read all I can find in the CCO doco but there isn't much in there.
Any suggestions will be happily accepted.
Kind regards, Ian.
IAN HUTCHINSON
Network Integration Consultant
245-249 St.Kilda Road
St.Kilda Victoria 3182
Desk 95361429
Mobile 0419 532 436
mailto://Ian.Hutchinson@Wang.com
or mailto://Ian.Hutchinson@Getronics.com
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:42 GMT-3