Re: ATM

From: Muralidhar Devarasetty (dhar_murali@xxxxxxxxxxx)
Date: Mon Jul 12 1999 - 10:52:22 GMT-3

   
Ben,
I think U require ATM switch for ATM switching.Router can be a LEC or it can
be made as LES/BUS.Here cat5 and router both are ATM edge devices.U req
device like LS1010.
Murali

----Original Message Follows----
From: "Ben Rife" <brife@bignet.net>
Reply-To: "Ben Rife" <brife@bignet.net>
To: "Scott F. Robohn" <sfr@ccci.com>
CC: <ccielab@groupstudy.com>
Subject: ATM
Date: Fri, 9 Jul 1999 23:40:28 -0400

Scott and Others,

     I'm starting to actually understand ATM. One question though, is it
possible to connect a router(s) to a CAT5 with a lane card w/o an ATM port
on the router? I am working on a CAT right now that has the following
modules:

Console> (enable) sh modu
Mod Module-Name Ports Module-Type Model Serial-Num
Status
--- ------------------- ----- --------------------- --------- --------- ---- 

---
1                       2     100BaseTX Supervisor  WS-X5009  003166390 ok
2                       12    10/100BaseTX Ethernet WS-X5213  001900579 ok
3                       2     MM OC-3 Dual-Phy ATM  WS-X5158  004930231 ok
5                       1     MM OC-3 ATM           WS-X5155  003378476 ok

Will this allow me to setup/configure LANE and route across it with my
connected routers?

Thanks,

Ben

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:42 GMT-3