ATM

From: Ben Rife (brife@xxxxxxxxxx)
Date: Sat Jul 10 1999 - 00:40:28 GMT-3

• Next message: Bill Carter: "OSPF over async"
• Previous message: Bill Carter: "Re: Book Evaluation request"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Scott and Others,

    I'm starting to actually understand ATM. One question though, is it
possible to connect a router(s) to a CAT5 with a lane card w/o an ATM port
on the router? I am working on a CAT right now that has the following
modules:

Console> (enable) sh modu
Mod Module-Name Ports Module-Type Model Serial-Num
Status
--- ------------------- ----- --------------------- --------- --------- ----

---
1                       2     100BaseTX Supervisor  WS-X5009  003166390 ok
2                       12    10/100BaseTX Ethernet WS-X5213  001900579 ok
3                       2     MM OC-3 Dual-Phy ATM  WS-X5158  004930231 ok
5                       1     MM OC-3 ATM           WS-X5155  003378476 ok
Will this allow me to setup/configure LANE and route across it with my
connected routers?
Thanks,
Ben

• Next message: Bill Carter: "OSPF over async"
• Previous message: Bill Carter: "Re: Book Evaluation request"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:41 GMT-3