From: Gopal K Naganaboyina (gopala.naganaboyina@xxxxxxxx)
Date: Thu Mar 02 2000 - 19:23:39 GMT-3
Ben,
I used this setup for some time. While this gave me the facility of
having 4 ports on my 2501, my config used to give problem once in a
while. Some times after i power cycle a router, the async port used to
go "up and reset ". The status keeps on toggling. I didn't find a fix
to this. I am not using this any more as i have enough routers for my
prep now. But this is just fine if you don't power-cycle your routers
too often. The config,
int asy 1
ip addr a.a.a.a m.m.m.m
encap ppp
!always ppp
asy mode ded
!enable routing to work on this
asy defa routi
asy dyn rou
Use Roll-over cable between the routers. PLease let me know if you
find a solution to the toggling prob.
Regards,
Gopal
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ben Rife
Sent: Tuesday, June 22, 1999 3:35 PM
To: ccielab@groupstudy.com
Subject: AUX Port
Hi guys,
I am wondering how to configure the aux 0 ports on my routers for
connectivity between two routers. I understand that I can route over
those ports. Can you give me some configs?
Thanks,
Benjy Rife
MCSE, CNE, CCIE Candidate
brife@bignet.net
www.bignet.net/~brife
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:39 GMT-3