From: Higgins, Andrew (Andrew.Higgins@xxxxxxxxxxxxxxxxxxx)
Date: Mon Jun 14 1999 - 22:56:53 GMT-3
Have you tried adding "async dynamic routing" to both Async interfaces?
-----Original Message-----
From: Brian Van Benschoten [mailto:vader@inxpress.net]
Sent: Monday, June 14, 1999 9:27 PM
To: ccielab@groupstudy.com
Subject: appletalk routing issue
Here are the pertinent parts. Remember that "appletalk protocol rtmp" is
the default and will not show up.
ROUTER 1
appletalk routing eigrp 250
appletalk route-redistribution
interface Async1
ip address 171.16.16.2 255.255.255.0
encapsulation ppp
async default routing
async mode dedicated
appletalk cable-range 16-16 16.2
appletalk zone 16-zone
ipx network CABE0016
r2#sh app int a1
Async1 is up, line protocol is up
AppleTalk port disabled, Acquiring port net information
AppleTalk cable range is 16-16
AppleTalk address is 16.2, Valid
AppleTalk zone is "16-zone"
AppleTalk discarded 8086 packets due to output errors
AppleTalk address gleaning is not supported by hardware
AppleTalk route cache is disabled, port down
ROUTER 2
appletalk routing
interface Async1
ip address 172.16.16.1 255.255.255.0
encapsulation ppp
async default routing
async mode dedicated
appletalk cable-range 16-16 16.1
appletalk zone 16-zone
ipx network CABE0016
4700#sh appletalk int a1
Async1 is up, line protocol is up
AppleTalk port disabled, Acquiring port net information
AppleTalk cable range is 16-16
AppleTalk address is 16.1, Valid
AppleTalk zone is "16-zone"
AppleTalk discarded 8097 packets due to output errors
AppleTalk address gleaning is not supported by hardware
AppleTalk route cache is disabled, port down
do you have your configs handy?
-----Original Message-----
From: Brian Van Benschoten [mailto:vader@inxpress.net]
Sent: Sunday, June 13, 1999 9:23 PM
To: ccielab@groupstudy.com
Subject: Appletalk issue
I'm having an issue getting AppleTalk routing to happen over an async
PPP
interface, between 2 routers. The interface always says its " acquiring
port net information" I have apple running fine every where else in the
internetwork. any ideas ?
I have Async default routing enabled and am getting IP OSPF and IPX RIP
over
the async interface just fine.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:38 GMT-3