From: Mark, Detrick (mdetrick@xxxxxxxxx)
Date: Wed Jun 09 1999 - 13:18:38 GMT-3
Folks,
I have noticed that respondents to messages on this board are not using
REPLY ALL. If you don't REPLY ALL the group does not see the response,
which undermines the intention of this board. Bottom line
ccielab@groupstudy needs to be included in your response.
Mark Detrick
DSL Business Unit
Cisco Systems
2569 McCabe Way
Irvine, CA 92614
----- Original Message -----
From: Ekis, Joel <Joel.Ekis@Connect.Xerox.com>
To: <vfortunato@erols.com>; Ekis, Joel <Joel.Ekis@Connect.Xerox.com>
Cc: <cisco@groupstudy.com>; <ccielab@groupstudy.com>;
<ciscotech@mailer.netcerts.com>
Sent: Wednesday, June 09, 1999 8:48 AM
Subject: RE: AppleTalk Zones & Ping Troubleshooting
> The routers were properly configured all cable-ranges, zones were defined
> properly. By the addition of this 'command' the zone information transfer
> between routers stopped, but you could still ping the AppleTalk addresses.
>
> Joel Ekis, CCNA, CCDA
> Xerox Connect
> Sr. Enterprise Consultant/Enterprise Network Services
> Phone: 913-696-0888, x234
> Pager: 800-697-0359
> joel.ekis@connect.xerox.com <mailto:joel.ekis@connect.xerox.com>
>
>
> -----Original Message-----
> From: Vincent.Fortunato@iscorp.bellatlantic.COM
> [SMTP:Vincent.Fortunato@iscorp.bellatlantic.COM]
> Sent: Wednesday, June 09, 1999 10:26 AM
> To: Ekis, Joel
> Cc: cisco@groupstudy.com; ccielab@groupstudy.com;
> ciscotech@mailer.netcerts.com
> Subject: Re: AppleTalk Zones & Ping Troubleshooting
>
>
> What do you mean by "zones were not being propagated between two
> routers"? Are you implying that no zones were configured at all,
> they
> were in two different zones, you had GZL filters running, or
> something
> else?
>
> Vince
>
>
>
> "Ekis, Joel" wrote:
> >
> > While studying, we were trying to recall an AppleTalk issue while
> discussing
> > possible CCIE troubleshooting scenarios:
> >
> > We recalled an instance where zones were not being propagated
> between two
> > routers, but you could still ping via AppleTalk through the
> routers. Does
> > anyone know about this symptom?
> >
> > What is the command(s) that causes this? How can you detect it
> via the show
> > & debug commands?
> >
> > Joel Ekis, CCNA, CCDA
> > Xerox Connect
> > Sr. Enterprise Consultant/Enterprise Network Services
> > Phone: 913-696-0888, x234
> > Pager: 800-697-0359
> > joel.ekis@connect.xerox.com <mailto:joel.ekis@connect.xerox.com>
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:38 GMT-3